Train Drawer Advent Calender Assembly Instructions
Here we have a step by step photo guide on how to put our advent together
You will need to use wood glue to secure the product together
Pieces you will receive
For the first step you will need the following pieces layed out in front of you (see picture below)
This part is the carriage at the back of the train.
Pick out the following pieces;
The two bars slot into the middle two gaps.
For the next step you will need the following pieces.
Each of these 3 bars slots onto the others already on the back piece.
Remember to make sure they are pushed all the way down so they touch the back piece.
You will now need the end pieces, these are slightly longer and go at the top and bottom.
The other two pieces you will have left are the other sides, one will have a hole in it as seen below.
Out of all the pieces, two end bars have holes, you need the one with the lower hole first.
The bar with a hole in must go on the left of the carriage, slot these pieces in, you may need to lift the inside bars slightly to help.
Now you can place the top piece on.
Now that the carriage is complete, you will need the following pieces for the train.
Out of these you will need to start with the backboard and middle bars (see image below)
Place these bars in the middle two slots.
The bar with two holes in the middle goes in the 2nd slot down.
Next you will need the middle bars that slot on top of these.
The two smaller bars go on the left and the longer ones go on the right.
Make sure the bars are pushed down all the way so they touch the back board.
You will now need the side pieces.
Slot the end pieces into the back pieces and then you might need to lift the inside bars slightly to help slot them on.
Make sure the smaller side pieces go where shown on the image as one has different slots at the end.
It is best to add your glue to these end pieces as it will hold the structure together.
Now the top piece of the train can be added which just slots on top.
You will have some small pieces left over and these are for decoration as 3D parts.
For help with these please watch our instrustion video at the bottom of this page.
Next the drawers
You will need the following pieces for each drawer plus wood glue to fix them together
In each corner join you will have a small rectangle and a large square.
Apply wood glue to all the lower teethed areas on all the sides of each piece
Once done bring all the pieces together to form a box
We also have an instuction video